Black Eagle Rampage Stainless Steel Bone Crushing Half-out - 300 Spine #33760

• Stainless Steel Half-out -- 250-400 Spine 50 Grains
• Quantity per pack: 12

To install the Half-Out.

1. Square the end of the arrow shaft
2. Dry fitting is recommended on all components. Slide half-out in shaft and spin test (if you prefer)
3. If a slight wobble is noticed, DON'T PANIC! Rotate the half-out with the field point installed until the spin is true.
4. Again, rotate half-out until it spins perfectly.
5. Use a silver or black Sharpie and mark the shaft and the half-out for perfect alignment once glue is applied.
6. We have tested our fletching glue, insert/outsert glue, and epoxy, and all of them work great.
7. Apply an even amount of glue around the shaft of the Half-Out to ensure the glue channels get enough glue in them to hold.
8. Once the glued half-out is finished, stand the arrow on the point to dry.